Installation manual

2. Set up of OverView mD
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
__________________________________________________________
____________________________________________________
__________________________
2-8
2.3 Installation of Safety Brackets
• Before the installation of the safety brackets check again the position of the supports.
• Each support has to be anchored by two safety brackets on the floor to avoid any movement.
Figure 2-11
Position of safety brackets
• The safety brackets have to be fixed to the floor by one securing screw and two securing screws on the
profile.
Figure 2-12
How to install the safety bracket
• Use a drill bit size 4.9mm to drill a hole in the profile in the position of the security pin.
• Force the security pin (size 5x32mm) into the hole.