Installation manual

2. Set up of OverView mD
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
__________________________________________________________
____________________________________________________
__________________________
2-2
2.1 Set up of Supporting Frame
The following tools are required to set up the supporting frame:
Size 5 and 6 hexagon keys.
Size 12 and 13 fork wrenches.
Size 10-socket spanner.
Precision spirit level.
Proceed as follows to set up a linear arrangement:
Positions of
adjustable feet
Front side
Back side
1
2
3
4
Figure 2-1
adjustable feet
• Unpack supporting frame, screw in the adjustable feet as far as possible, and position frames at required
place.
• Adjust the supporting frame.
Using the adjustable feet 1 and 2, first adjust the front axis of the first supporting frame exactly horizontally
(use precision spirit level). Secure feet using counter nuts.
Subsequently align the depth axis exactly horizontally using adjustable feet 3 and 4. Also secure the feet
using counter nuts.
Once the supporting frame has been aligned, unscrew the feet 5 and 6 until they support the load. Carefully
check that the alignment of the supporting frame is not changed in the process (check using spirit level).
First adjust supporting frame 1, and then align and adjust the adjacent frames with respect to this.
• Attach the supporting frames to the floor via the lower anchoring devices