Installation manual

10. Manual User Interface
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
_________________________________________________________
__________________________________________________
_________________________
10-1
10 Manual User Interface
The manual user interface located at the rear of OverView D includes the switches of the illumination unit [A],
[B], [C], the LED’s of the illumination unit, and the LED’s of the lamp doors.
The manual user interface is intended to operate the projection module when servicing. The trained Barco
support technicians can analyze errors by evaluating the status of the LEDs.
Figure 10-1
detail of rear view OverView mD
10.1.1 Power Switch
The power switch [A] connects/disconnects the projector from the mains. Once switched on, the projector should
be disconnected from the mains only for servicing.
Do not press the power switch while the projector is running. The projector has to be
switched to Standby first!