Installation manual

8. Final Adjustment and Configuration
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
_________________________________________________________
__________________________________________________
_________________________
8-41
To change the specified runtime:
• Move the cursor key to the respective field.
• Enter the new value by means of the numeric keys of the IR Remote-Control.
in Hot Standby mode. the warning pops up if the operation time of one of the lamps
exceed the specified value.
In Cold Standby mode: the warning pops up if the operation time of the active lamp
exceeds the specified value.
8.5.13.5 Lamp Top Serial Number / Lamp Bottom Serial Number
This menu allows to change the serial number of the currently used lamp, and should be used in conjunction
with the menu Write Lamp Runtime as mentioned above.
Figure 8-62
Enter serial number (after lamp exhange)
Use these commands when exchanging lamps within a Display Wall.