Installation manual

8. Final Adjustment and Configuration
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
_________________________________________________________
__________________________________________________
_________________________
8-39
8.5.13.2 Write Lamp Runtime
This command opens a sub menu where the runtimes of lamp top and lamp bottom can be changed. This
function is intended to be used together with the function Lamp Top Serial Number and Lamp Bottom Serial
number. These two commands together allow exchanging lamps within a Display Wall and keep tracking of their
runtimes.
Figure 8-57
Service|Lamps|Write Lamp Runtime
8.5.13.3 Read Lamp Voltage
This new function allows the estimation of the burner voltage. Pressing this button will open a sub menu which
shows the voltage value after a few seconds measurement time. This measurement is based on some optical
properties which are measured and used for voltage determination.
Make sure to select the correct lamp driver! Otherwise the displayed values are invalid!
Figure 8-58
Service|Lamps|Read Lamp Voltage