Installation manual

1. Assembly of support frame
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
__________________________________________________________
____________________________________________________
__________________________
1-6
• Install the multi socket angle (position see Figure 1-1 [2])
The power strip includes 6xIEC 320 sockets and is rated for a max. current of 10A.
Always take care that the max. rating of the power strip is not exceeded!
In case the installation site is in a 110V country, and in case the display wall is higher than
3 rows, an additional power strip has to be installed.
Of course the two power strips may not be connected in serie!
In 110V countries, at max. 3 darkboxes may be connected to a power strip!
In case a second power strip is required, proceed as follows:
• De-mount the power strip attached to the multi socket angle.
• Unpack the second power strip: it is already attached to the metal base plate.
• Fix the de-mounted power strip to the metal base plate of the second power strip.
• Attach the metal base plate to the angle bracket.
The following picture sequence shows the procedure stept by step: