Installation manual

8. Final Adjustment and Configuration
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
_________________________________________________________
__________________________________________________
_________________________
8-27
8.5.6 Maintenance
Figure 8-36
Service menu: Maintenance
8.5.6.1 Color Wheel Alignment
This setting specifies the delay value between the color wheel index signal and the DLP electronics. Each step
equals 100 ns.
The value is specific for each color wheel cassette and will be programmed in production.
Do not change/alter this value!
In case of color wheel exchange a new delay value has to be entered by the support
engineer. This specific delay value will be shipped together with the spare color wheel
To enter a new delay value, proceed as follows:
• On the service menu entries, move the cursor to Color Wheel Alignment
• Press Enter to select.
A dialog box pops up to enter the new value:
Figure 8-37
Index Delay
Arrows pointing to the left decrease a value, arrows pointing to the right increase a value.
Clicking on a single arrow increases (
4
) /decreases(
3
) the value per 1.
Clicking on the double arrows increases (
44
) /decreases (
33
) the values per 10.
Clicking on the right most / left most arrow sets the value to the maximum or minimum (0).