Installation manual

8. Final Adjustment and Configuration
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
_________________________________________________________
__________________________________________________
_________________________
8-26
8.5.5 Orientation
Figure 8-35
Service menu: Orientation
For DLP projection engines incorporated in OverView D systems, this menu entry is irrelavant: The orientation of
the projection engine is fixed and defined as Front/Ceiling. However, in case your picture is displayed upside
down, it might be recommended to check the orientation set on this menu.
(The other orientations are required for test situations with the engine NOT installed in the structure.)
• To check the set orientation, proceed as follows:
• Move the cursor keys to highlight Orientation.
Press Enter to select.
The possible orientations are displayed. The actual orientation is indicated by a white dot:
For OverView D series, the only correct orientation is Front/Ceiling!