Installation manual

8. Final Adjustment and Configuration
OverView D 50" – DOC-3303-5 – installation manual – Revision 11 – November 2006
________________________________
________________________________________________________________
_________________________________________________________
__________________________________________________
_________________________
8-24
To change the values
• Increase
4
or decrease
3
the value by means of the arrow keys.
The menus vanish by pressing Exit on the IR Remote-Control unit or if there is no change
within 5 seconds.
Please note:
These settings are only valid for the optical dimmer being disabled. In case the optical
dimmer is enabled again, these settings are set back to their neutral positions (50)!
8.5.4.6 DIS Calibration Factor
The DIS Calibration Factor is determined by CAST.
Only experienced user equiped with a lux meter should change the value!
All DIS values that are displayed and used in the projector are composed by the raw data of the DIS multiplied by
a calibration factor.
taDIS raw dan factor)*-correctioor *(ratin Fact DIS CalibDIS value 1=
This calibration factor can be set by means of the menu Service | Color/Brightness | DIS calibration factor.To
change the calibration factor:
• Use the cursor key to highlight DIS Calibration Factor.
• Press Enter to select.
The current DIS Calibration Factor is displayed.
Figure 8-33
DIS calibration factor
The DIS Calibration Factor can only be changed for the active lamp!
The DIS Calibration Factor can be changed between 1.000 and 9.999
The DIS Calibration Factor is set for both lamps individually.