Specifications

Driver and Software Installation

7. When the Setup complete message appears, select Reboot

System Now and click Finish.

8. After the system reboots, Windows may display either the

Digital Signature Not Found message or The software you are

installing for this hardware has not passed Windows logo

testing.

Automated display configuration

Once the drivers, software and documentation have been installed

and your system has been rebooted, the Barco Monitor Plug and Play

Software should automatically detect your Barco displays and attach

them to the desktop with the correct resolution. If the Barco Monitor

Plug and Play Software fails to detect your Barco displays or fails to

attach them to the desktop correctly please refer to the section,

Setting the resolution of your Barco Coronis Display in the

Configuring Windows section of this manual.

Reinstalling drivers

You can install new drivers or reinstall existing drivers at any time by

using the Barco Set-up wizard on your B

ARCO CORONIS 5MP MAMMO

Display System Installation CD-ROM, see Installing the B

ARCOMED

ORONIS or Nio drivers and software, on page 58 of this manual.

Uninstalling the drivers and software

To uninstall the Barco drivers, software or documentation for your

Barco Coronis 5MP Mammo Display Systems, please use the Windows

Add/Remove Programs or Uninstall utility. This can be found in the

Windows Control Panel. For Vista use Programs & Features

Note: If you installed your B

ARCOMED CORONIS or Nio drivers with

DualView enabled, the wizard will warn you that DualView must

be disabled before the drivers can be uninstalled. This is normal,

please follow the prompts from the wizard.