Specifications

Display Controller Installation
36
11. Reconnect any cables you have disconnected and plug in the
computer’s power cord.
12. Turn on the display(s) and then your computer.
Turning on your system
If you have properly installed your graphics card, the Windows
start-up messages will appear once the boot procedure is
finished.
Note: Your Barco display(s) will be running in a basic video
mode at a default refresh rate. Higher resolutions and refresh
rates, such as 1536x2048@60Hz, are not available at this stage
of the installation. Once you have installed the B
ARCO CORONIS
5MP M
AMMO Display System drivers and software, the Barco
monitor Plug and Play software should automatically set the
resolution for the displays.
13. Install the drivers, QAWeb software and documentation for your
B
ARCO CORONIS 5MP MAMMO Display System by following the
instructions in the Driver and Software Installation section of
this manual.
WARNING - Turn on your display(s) before you turn on
your computer. Failure to do so could damage your dis-
play(s).