User manual

Chapter 2. Configuration Utility
Barco TouchScreen Controller 25
<Edge Compensation Switch>
Users can Enable / Disable Edge compensation at the left bottom
corner of Touchkit Utility.
The +10% and -10% buttons will adjust the edge settings.
If you press the +10% button, the top, bottom, left and right
edges will extend by 10% and the Offset X and Y Axis settings
increase with 10 pixels.
If you press the -10% button, the top, bottom, left and right
edges will decrease by 10% and the Offset X and Y Axis settings
decrease with 10 pixels.
Click Default to restore the default settings.
Hardware
The Hardware tab page shows information of interface, type,
firmware version for the selected controller.