User manual

Chapter 2. Configuration Utility
Barco TouchScreen Controller 21
1219 TS is connected to by double-clicking it. The head
number will become white when selected.
When using a split desktop setup, special setup is needed
(see See <Split desktop setup> on page21.).
3. Now touch the touch screen. If the mapping is correct, the
pointer will appear on the correct screen. If the pointer
appears on the wrong screen, the mapping is incorrect.
Please repeat the steps above and select the correct display
head.
Note: Mapping of monitors needs to be redone when a touch
screen is plugged into a different USB port.
<Split desktop setup>
Split desktop setup is needed when your graphics board uses a
spread desktop, spread over 2 or more monitors. There are
several operation modes you can select from, at the bottom of
the Display control page.
To use the Split desktop function, in the General tab page you
need to select which touch screen controller you want to define
the location and resolution for.
Make sure that Enable Multiple Monitors is checked.
You can select from a number of standard modes: Full Screen,
Lower Screen, Left Screen, Upper Screen and Right Screen.
Additionally you can customize the active area. Therefore select
Other and click the [>>] button. The following screen appears: