User manual

Chapter 2. Configuration Utility and Right Button Emulator

28 Barco TouchScreen Controller

Split monitor is needed when your graphics board uses a spread

desktop, spread over 2 or more monitors.

To use the Split Monitor function, you need to select which touch

screen controller you want to define the location and resolution

for.

Make sure that Multiple Monitors and Split Monitor are both

enabled.

Press [Split Setting] to set up the activate area.

It shows the current resolution of display and users can set up the

activate area by inputting the value by yourself or use the default

button [Upper Half], [Left Half] or [Quarter]. The default value

of panel resolution should be full screen as Left: 0, Right: 0, Top:

0 and Bottom: 0.

The Touchkit utility provides a fast tool to identify the

touchscreen orientation when the monitor display was rotated by

90 degrees.

When enabled, Touchtray will pop up the One Point Calibration

tool for users to identify and correct the touchscreen / monitor

orientation whenever the monitors was rotated by 90 degrees.

When disabled, Touchtray does not pop up the One Point

Calibration tool. Then, the user has to do the 4-points calibration

to correct the orientation whenever the monitor was rotated.