User manual

Chapter 2. Configuration Utility and Right Button Emulator
Barco TouchScreen Controller 27
After finishing monitor mapping, Press [Apply] to apply the
mapping relation!!
Special Case:
When you have a dual (or more) screen setup and you have only
one (or more minus 1) touch screen display, you cannot use the
mapping tool (it will ask you to touch each screen, and you can
only "touch" one since there's only one touch screen).
In this case you need to map the single touch screen manually,
which is done as follows:
1. Select the touch screen controller in the Monitor Tab.
2. Now select the display head (layout is the same as in
"Display settings - Settings") where the MFCD 1219 TS is
connected to by clicking it. It will become gray when
selected. When using the split monitor function, we need to
define the location (in pixels) & resolution where the display
is present (see <Split Monitors> on page 28).
3. Press Apply to apply the setting.
4. Now touch the touch screen. If the mapping is correct, the
pointer will appear on the correct screen. If the pointer
appears on the wrong screen, the mapping is incorrect.
Please repeat the steps above and select the correct display
head.