User manual

Chapter 2. Configuration Utility and Right Button Emulator

26 Barco TouchScreen Controller

Monitors

There are three functions in this property page: Multiple

Monitors, Split Monitor and One Point Calibration.

To configure the mapping relationship between the monitors and

the touch panels, select the monitor page as below.

Set the check box (Use Multiple Monitors) to enable multiple

monitors mapping. Unchecking this box will disable multiple-

monitor configuration, and all of the touch panel controllers will

be mapped to the primary monitor. The gray shadow area is the

monitor mapped the selected controller/panel. The button

[Mapping] is used to map the relationships between the

monitors and touch panel controllers.

Press [Mapping]. The software will prompt to touch the

corresponding monitor to obtain the mapping relationship.

Touch the screen that says "touch". Repeat for every screen.