User`s manual

5. Menu and toolbar
Barco – iStudio – R5976569 – user's manual – revision 09 – March-2007
____________________________________________________________________________________
5-63
5.5.3 Load, cut and paste object properties
The following commands have mostly the same function as the respective commands for a single object. They
help to assign object properties, but instead of assigning it to a single object they are assigned to all objects of
the selection. All properties of an object except position, size and the source can be saved as template and reas-
signed. For comparison please refer to section
5.6.5 Cut, copy, paste and paste new object properties.
Load objects
With the command Load objects... the Load objects dialog box is opened. In brackets in the title bar of the dia-
log the available size on the flash disk in KB is indicated. The properties of a saved object can be assigned to all
objects that are selected on the work area by clicking the name of the object properties you want to load or type
the name into the Filename box and press OK.
Figure 5-46
Load objects dialog box
To load objects, use also the button.
Cut objects
This command deletes all objects of the selection.
In contrary to the command Cut object with this command here there are no object
properties copied to the clipboard.
To delete objects, use also the button.
Paste objects
This command assigns to all objects of the selection the object properties of a single object which were copied
before by means of the commands copy object or cut object, please refer to section
5.6.5 Cut, copy, paste and paste
new object properties. Also the name of the original object is copied to the selected object. The selected objects
maintain their originally assigned sources.
To paste objects, alternatively use the
button.