User`s manual

5. Menu and toolbar
Barco – iStudio – R5976569 – user's manual – revision 09 – March-2007
____________________________________________________________________________________
5-42
Protocols tab
On the Protocols tab the settings for the logical signal processing system Andromeda can be set.
Andromeda is a protocol used to control the contents of UMDs (source name) and tallies. It is based on RS-232
serial communication. Therefore the serial port [1] on the single board computer on the H
YDRA must be used and
for Device on the Andromeda tab the entry ttyS0 must be selected. With the Baudrate list select the relevant
value of the signal. The Swap tallies checkbox enables to rotate the tallies. With the Enabled checkbox the usage
of the Andromeda system can be enabled.
Figure 5-32
Module properties dialog – Protocols tab