User`s manual

5. Menu and toolbar
Barco – iStudio – R5976569 – user's manual – revision 09 – March-2007
____________________________________________________________________________________
5-36
Boards tab
On the Boards tab all slots of the H
YDRA are listed including the inserted boards and their version. The number in
square brackets indicates the slot, followed by the type of board, while v0, v1, ... stands for version 0, version 1
and so on. If Streaming video boards or output boards are selected, additional configuration options appear on
the right part of the dialog:
Streaming video card
If your system is equipped with Streaming video cards, you should configure the IP address, Netmask and
Gateway of the Streaming video card. As well select the appropriate compression algorithm. A list with the pos-
sible compression algorithms for various encoders can be found in section
5.3.5 Setup encoders.
NG Streaming Video Card
NG Streaming video cards are listed with the name 4-J2KDecoder vx .
The most top Network section can be used to configure a port for service interaction of the board. The related
connectors on the board are the two lower ones. The can be used for a redundant connection. Configuration of
this port is not required for standard operation.
The necessary settings are IP address and Netmask in the Network(Gb) section and Gateway in the General
section. They are used to configure the two upper connectors of the board, which establish a redundant connec-
tion to the video network.
Figure 5-28
Module properties dialog – Boards tab –Streaming video card (left) and NG Streaming video card (right)