User`s manual

5. Menu and toolbar
Barco – iStudio – R5976569 – user's manual – revision 09 – March-2007
____________________________________________________________________________________
5-31
Screen tab
On the Screen tab the format for internal data processing is set. These are usually also the output settings. Any-
how, depending on the output card, also differing output resolution and timing can be set. This is done on the
Boards tab, please see below.
Figure 5-26
Module properties dialog – Screen tab
The Resolution list provides a collection of settings, either named after the device, or after resolution and timing
itself. Individual timings can be edited by means of the
5.2.8 Setup timings dialog. Dual settings are used, if two
projection modules are connected to one H
YDRA in dual mode, see section 8.4 Dual mode. For dual mode for dis-
play devices with pixel clock higher than 68MHz the appropriate internal timings must be used.
Timings for SXGA+ and UXGA resolutions which do not have the word native in their name perform pixel dou-
bling. Pixel doubling is explained in section
8.4 Dual mode. Timings with the word native in their name process
the complete amount of pixel throughout the whole image generating process.
The settings PAL SDI, PAL SDI Dual, NTSC SDI, PAL CVBS, PAL CVBS Dual, NTSC CVBS and NTSC CVBS Dual are espe-
cially useful with the DVI video output card; please refer to Boards tab below.