User`s manual

5. Menu and toolbar
Barco – iStudio – R5976569 – user's manual – revision 09 – March-2007
____________________________________________________________________________________
5-29
5.3.4 Setup module
The command Setup module… opens the Module properties dialog. By means of this dialog the properties of
the projection module and the H
YDRA can be set. These are:
• General settings (name, geometry, region, etc. )
• Screen (selection of output signal)
• Network settings of the H
YDRA
• Boards (list of all boards used in the H
YDRA and additional, type dependent board configuration)
• Connected sources (configuration of the video and RGB sources)
• Startup options
• Alarm settings
• Settings for the use of the Andromeda protocol
Changing the name or wall name in the H
YDRA properties, requires the command Reboot
module for the concerned H
YDRA or Reboot wall, if name properties of multiple HYDRAS are
changed. Please refer also to section
5.3.2 Module control and 5.2.5 Wall Control respectively.