User`s manual

5. Menu and toolbar
Barco – iStudio – R5976569 – user's manual – revision 09 – March-2007
____________________________________________________________________________________
5-23
5.2.11 Setup NGM-164…
The NGM-164 encodes for up to 64 audio sources audio meters and audio alarms into one compound audio
stream. If this stream is available on the network to that the H
YDRA connects to, the HYDRA is able to decode the
stream and provide the contained audio sources for monitoring.
The Setup NGM-164 dialog provides access to the configuration of the NGM-164 and allows the configuration of
the scales of the audio sources.
A H
YDRA is able to receive and process audio streams of multiple NGM-164 devices. For each stream the device
and the stream has to be specified. Therefore first enter a name for the NGM-164 into the Name field and click
Add. After that the configuration parameters can be added to the fields in the lower part of the dialog. To delete
an NGM-164 configuration, select the device from the list on the left and click Delete.
In the Audio Stream section the stream itself is configured. In the Destination box enter the multicast address
of the stream and in the Port box the port number for the stream.
In the NGM-164 section the network settings of the NGM-164 which are needed to connect to the device are
listed; in the Destination box enter the IP address of the NGM-164, and in the Port box enter the port number
for connecting.
If the Enable checkbox is selected this audio stream is decoded and its sources are considered in the general
sources list. As long as the checkbox is deselected the respective audio stream can be defined but it is not used
in the H
YDRA.
Figure 5-21
Setup NGM-164 dialog