User`s manual

5. Menu and toolbar
Barco – iStudio – R5976569 – user's manual – revision 09 – March-2007
____________________________________________________________________________________
5-20
5.2.8 Setup timings
The Setup timing dialog allows to define timings or to change the settings of an existing timing. To use these
timings please refer to section
5.3.4 Setup module (Screen tab).
The timings list contains all stored timings. Click the Add button to add a new timing. In the Add timing dialog
enter the name of the new timing. If you want to use an existing timing as template, select Copy from existing
timing and choose the respective timing from the list. Click OK to confirm.
Select from the Timings list the timing that you want to adapt. The Split output setting is used to create a dual
timing, refer to section
8.4 Dual mode. When preparing a timing for a device that is not in the timings list the val-
ues supplied by the manufacturer must be entered into the upper part of the dialog. When all fields are adjusted
click the Calculate button, which uses the entered values to calculate all timings settings. They are displayed in
the lower part of the dialog. In general these values can be used without further adaptation. But in case that
some fine-tuning is required enable the Edit settings manually checkbox and adjust the required value manu-
ally.
When done, click OK to confirm your work.
Figure 5-18
Setup timings dialog