User`s manual

5. Menu and toolbar
Barco – iStudio – R5976569 – user's manual – revision 09 – March-2007
____________________________________________________________________________________
5-17
Time Setup – Wall – manual configuration
The manual configuration enables to set the time for the clocks of all H
YDRA modules to the date and time speci-
fied in the text boxes of the Manual time configuration dialog. Pressing the Get button shows the current time
and date of that H
YDRA that is used for the connection to the operator PC. Instead of the Get command, data and
time can be entered manually.
Pressing the Set button sets the time and date currently displayed in this dialog to all HYDRA modules.
The H
YDRA modules are only synchronized with each other in that moment where the Set button is pressed; later
on their clocks are no more synchronized.
Figure 5-15
Setup time dialog – manual configuration
If the wall or a module has already been operated in a different time configuration mode (NTP,
NTP-date or LTC/VITC), then please perform the following steps in the order given below, before
switching to manual time configuration:
• Select Manual time configuration, which means de-select NTP Synchronization.
• Click the OK button.
• Perform a software reset for all modules that had a different configuration before; please refer
to section
5.2.5 Wall Control or 5.3.2 Module control.
• Open again the Setup time dialog.
Now you can perform the manual time configuration as explained above and the time of the H
YDRA
modules gets set accordingly.