User`s manual

5. Menu and toolbar
Barco – iStudio – R5976569 – user's manual – revision 09 – March-2007
_____________________________________________________________________________________
5-8
5.2.3 Wall scenario
The Wall scenario command enables to display various wall layouts in a user-defined chronology. The Wall
layouts list provides all wall layouts. With the Add button a selected wall layout can be added to the Scenario
list. The Cut button removes a selected item from the Scenario list. The New button clears the whole Scenario
list. The time each wall layout is displayed can be inserted in seconds into the Wait box.
The Start and the Stop buttons start and stop the scenario. The Close button closes the Wall scenario dialog box.
If a scenario was running at this time it is stopped as well.
Figure 5-6
Wall scenario dialog box
After starting a scenario the Wall scenario dialog box must be left open as long as the scenario shall
be displayed!
Nevertheless the iS
TUDIO software can be operated. The Wall scenario dialog box hides in the back-
ground. It can be brought to the foreground again either by clicking on its icon in the Windows task
bar or by pressing the shortcut key Alt Tab as long as the dialog box is selected.
Wall scenarios can not be saved. To save a sequence of wall layouts a Wall script or the H
YDRA open
protocol can be used, see below.