User`s manual

5. Menu and toolbar
Barco – iStudio – R5976569 – user's manual – revision 09 – March-2007
_____________________________________________________________________________________
5-6
A list with all modules appendant to the wall can be found in the Module column. The Load layout checkbox
must be selected for each module where a layout shall be assigned. If the Load layout checkbox is not selected
the respective module becomes not updated when a wall layout is loaded. In the Layout list finally an existing
layout can be assigned to a module.
After assigning the layouts as desired the wall layout can be saved, therefore click the Save button. This opens
the Save wall layout dialog. In brackets in the title bar of the dialog the available size on the flash disk in KB is
indicated. Either enter the name of the wall layout into the Filename box or click on a filename in the list to
overwrite this existing wall layout. Click OK to confirm.
Figure 5-3
Save wall layout dialog box
Edit wall layout…
Already existing wall layouts can also be edited. This is accomplished with the Edit wall layout command. The
Edit wall layout dialog box shows a list of all wall layouts. After selecting one wall layout and clicking OK, the
same dialog as under the New wall layout appears.
If the currently displayed wall layout is edited nevertheless it must anew be loaded, to display the changes.
Load wall layout…
With the Load wall layout command a wall layout can be selected and displayed on the projection modules. The
layout of the single modules can be seen in the display area. It can be switched between the different modules
by clicking on the respective module in the modules tree.
Delete wall layout…
The Delete wall layout command enables to delete a wall layout. If the actually displayed wall layout is deleted
nevertheless the same information is displayed until another wall layout or layout is loaded.