User`s manual

3. Getting started
Barco – iStudio – R5976569 – user's manual – revision 09 – March-2007
_____________________________________________________________________________________
3-5
Now the Login window is displayed.
Figure 3-5
Login window
Into the Password box insert the required password and click Login or press the Enter key. Now the iSTUDIO
software can be used. The factory set passwords are:
Administrator: admin
User: user
Table 3-2
Factory set passwords
Switching on multiple Hydras
Switch on all H
YDRAS with the power button at the front of the HYDRA. Start the iSTUDIO software by connecting to
one of the H
YDRAS with the web-browser, as explained above. Just one HYDRA can be indicated in the address bar
of the browser, but this enables to operate each H
YDRA that belongs to the same wall. Within the iSTUDIO software
it can easily be switched between all related H
YDRAS, please refer to section 6.2.1 Modules.
3.2.2 Switching off
Before the HYDRA can be switched off, it must be halted. To halt a module select Halt module from the Module
menu or select Halt wall from the Wall menu, see section
5.3.2 Module control and 5.2.5 Wall Control. This command
halts one or all H
YDRAS. As soon as the HYDRA stops sending an output signal, it can be switched off, please refer
to the H
YDRA user’s manual.