User`s manual

11. Appendix A - Hydra Open Protocol
Barco – iStudio – R5976569 – user's manual – revision 09 – March-2007
__________________________________________________________________________________
11-32
Set source freeze
Freeze or unfreeze a source of a module of the H
YDRA wall.
Note: This command is not yet applicable. Further development of this element follows.
Send
<COMMAND ID="setsourcefreeze" SERIAL="example">
<MODULE ID="module2">
<SOURCE ID="0">0</SOURCE>
<SOURCE ID="10">1</SOURCE>
<SOURCE ID="20">0</SOURCE>
</MODULE>
</COMMAND>
For each source specify: module name, source number (0 - n), new state.
Receive
<COMMANDRESULT SERIAL="example" ERROR="0">
</COMMANDRESULT>
See also getmodulestate, getsourcefreeze
Get source tally
Get the state of a tally of a source of a H
YDRA module.
Send
<COMMAND ID="getsourcetally" SERIAL="example">
<MODULE ID="module2">
<SOURCE ID="9">
<TALLY ID="0"></TALLY>
<TALLY ID="1"></TALLY>
<TALLY ID="2"></TALLY>
</SOURCE>
<SOURCE ID="18">
<TALLY ID="1"></TALLY>
</SOURCE>
</MODULE>
</COMMAND>
For each tally specify: module name, source number (0-n), tally number (0-2)
Receive
<COMMANDRESULT SERIAL="example" ERROR="0">
<MODULE ID="module2">
<SOURCE ID="9">
<TALLY ID="0">
<STATE>0</STATE>
</TALLY>
<TALLY ID="1">
<STATE>1</STATE>
</TALLY>
<TALLY ID="2">
<STATE>0</STATE>
</TALLY>
</SOURCE>
<SOURCE ID="18">
<TALLY ID="1">
<STATE>1</STATE>
</TALLY>
</SOURCE>
</MODULE>
</COMMANDRESULT>
See also getmodulestate, setsourcetally