User`s manual

11. Appendix A - Hydra Open Protocol
Barco – iStudio – R5976569 – user's manual – revision 09 – March-2007
__________________________________________________________________________________
11-29
Halt module
Halt the specified module.
Note: If you want to halt multiple modules and also the module where you are connected to, then put this mod-
ule on the last place in the command. It is also more efficient to use haltwall if you want to halt all modules.
Send
<COMMAND ID="haltmodule" SERIAL="example">
<MODULE ID="module3"></MODULE>
<MODULE ID="module1"></MODULE>
</COMMAND>
For each module specify: module name
Receive
<COMMANDRESULT SERIAL="example" ERROR="0">
</COMMANDRESULT>
See also haltwall, rebootwall, rebootmodule, resetmodule, softwareresetmodule, softwareresetwall