User`s manual

11. Appendix A - Hydra Open Protocol
Barco – iStudio – R5976569 – user's manual – revision 09 – March-2007
____________________________________________________________________________________
11-8
haltmodule 11.3.6 Module related commands, halt a module
haltwall 11.3.5 Wall related commands, halt all modules of the wall
initstreams 11.3.7 Source related commands, initializes a video stream in a module
loadfile 11.3.3 File related commands, get a stored file
loadlayoutandupdate 11.3.6 Module related commands, show a stored layout on one module
loadwalllayoutandupdate 11.3.5 Wall related commands, show a stored wall layout on the wall
rebootmodule 11.3.6 Module related commands, reboot a module
rebootwall 11.3.5 Wall related commands, reboot all modules of the wall
resetmodule 11.3.6 Module related commands, reset a module
resetwall 11.3.5 Wall related commands, reset all modules of the wall
savefile 11.3.3 File related commands, store a file
setalarmconfig 11.3.7 Source related commands, set the alarm configuration of a source
setmoduletime 11.3.6 Module related commands, set the time of a module
setsetupcolors 11.3.5 Wall related commands, set the definition of the colors
setsetupmodule 11.3.6 Module related commands, set the setup of a module
setsetupsource 11.3.7 Source related commands, set the setup of all sources of a module
setsetupusermode 11.3.5 Wall related commands, set the user mode setup of the wall
setsourcefreeze 11.3.7 Source related commands, freeze or unfreeze a source
setsourcename 11.3.7 Source related commands, set the name for a source
setsourcetally 11.3.7 Source related commands, set the tally state for a source
setsourcetallyonobject
11.3.10 Tally related commands, set tally state of hardware tallies of video
objects
setstream 11.3.7 Source related commands, assign a stream of a module to a source
setwalltime 11.3.5 Wall related commands, set time of all modules of the wall
softwareresetmodule 11.3.6 Module related commands, reset the software of a module
softwareresetwall 11.3.5 Wall related commands, reset the software of all modules of the wall
updatelayout 11.3.6 Module related commands, transfer a layout to a module and display it
Table 11-1
Overview of commands