User`s manual

4. Operating
Barco – Hydra Compact – R5976568 – Revision 14 – September-2007
________________________________________________________________________________________
4-3
Take care not to use the entry »default settings« as this applies other settings than
mentioned above. Nevertheless if so, please readjust the BIOS to the above Hydra Compact
settings!
4.1.3 Boot agent settings
For the single board computer SBC/2 it is important that the boot agent uses correct settings to prevent it to try
to boot from the network, which would increase startup time of the H
YDRA COMPACT. These settings are pre-
configured in your H
YDRA COMPACT. In case they have been changed, please use the table below as a reference to
readjust the settings.
The settings of the boot agent of the SBC/2
path setting
Network Boot Protocol PXE
Boot Order Int 18h
Show Config Message Enable
Show Message Time 3 Seconds
Table 4-3
Realtek boot agent settings
After readjusting the settings, press the F4 key to save the changes and quit.
4.1.4 Finishing the setup of BIOS and boot agent
• After selecting the appropriate settings save the settings and exit the BIOS or boot agent setup.
• Halt the H
YDRA COMPACT and switch it off again, please see above.
• Now you can safely disconnect monitor and keyboard from the SBC.
• The H
YDRA COMPACT can be taken into its usual operation again.