User`s manual

3. Getting started
Barco – Hydra Compact – R5976568 – Revision 14 – September-2007
_______________________________________________________________________________________
3-19
3.3 Starting Up
3.3.1 Connecting
First of all you have to provide the appropriate power supply. Plug in the power cable on the back panel of your
H
YDRA COMPACT. Please, refer to section 3.2.1 Power supply!
Connect your H
YDRA COMPACT to the local area network! Connect the network to the Ethernet connector of the
single board computer! Please, refer to section
3.2.2 Single board computer!
Connect your video sources to the video input cards and the RGB sources to the RGB input cards, if advisable use
the patch panel. Please, refer to section
3.2.4 Video Input Card, 3.2.5 RGB Input Card and 3.2.8 Patch panel!
Connect the intended display devices to the output card. Please, refer to section
3.2.6 Output Card!
If information of an NGM-164 is used check that it is connected to the LAN; please refer to section
3.2.7 NGM-164.