User`s manual

3. Getting started
Barco – Hydra Compact – R5976568 – Revision 14 – September-2007
________________________________________________________________________________________
3-7
3.2.2 Single board computer
The HYDRA COMPACT is connected to the LAN via the Ethernet connector on the single board computer.
Connectors
The connectors of the single board computer are not only on the front plate of the single board computer but
also on a corresponding slot plate for the serial port, please see the figure below.
1
r
2
3
4
5
6
r
1 serial port
2 VGA connector (only used for service)
3 green LED
4 Ethernet connector
5 yellow LED
6 PS/2 keyboard or PS/2 mouse (only used for service)
r reserved for future use
Figure 3-5
Ports of single board computer /2 and corresponding slot plate
To connect the HYDRA COMPACT to the Ethernet connector [4], a 100Base-T cable with twisted transmitter and
receiver pairs must be used.
Besides a PS/2 keyboard/mouse connector [6] and VGA connector [2] (both not used during standard opera-
tion of the H
YDRA COMPACT) there is a standard serial port connector [1].
Order
The single board computer is always inserted to the left in the first slot with the slot plate in the next slot to the
right (counted from left to right, if looking to back on the H
YDRA COMPACT).