Operating instructions

System manual ImageTile 94
etatSSMPD sgnivaSrewoP
rotinoM
emiTyrevoceR
nOenoNA/N
yb-dnatSlaminiMtrohS
dnepsuSlaitnatsbuSregnoL
ffOmumixaMtsegnoL
Monitor Settings
Select the amount of time the monitor requires to warm-up. Since all
CRT based monitors require some warm-up time before they are at
full performance, this ensures that the monitor is ready for use at the
beginning of the work day.
If you have a Barco Medical Monitor, select “Barco Quick Start.” If a
non-Barco monitor is being used, select the amount of time it takes
your monitor to warm up via the “Monitor Setting” section. Contact
your monitor vendor for this warm-up time.
On Barco ImageTile displays, the I-GUARD will stabilize the image
within a few seconds after the monitor returns to the active state so
there is no need for a warm-up time period.
Use As Logon Screen Saver
Check the box to use the Barco Metheus DPMS Screen Saver when
no one is logged into the system.
Uncheck the box to use the default screen saver when no one is
logged into the system.
Installing the BarcoMetheus DPMS Screen
Saver
To install the DPMS Screen Saver, you must have the Microsoft
Windows Installer program installed on your system. To verify that it is
installed use Windows Explorer to search for the following file:
“msiexec.exe”. If you do not find this file, you can install it from the
BarcoMed Software CD by following the steps below. If the Windows
Installer is installed on your system skip to step 5 below.
1. Insert the BarcoMed Software CD in your system’s CD drive.
BarcoMed software driver installation