Operating instructions

System manual ImageTile 93
work day. This “regular” screen saver and its settings can be chosen
from the “Screen Saver During Work Day” section. We recommend
using an all black screen saver, such as the “Barco Metheus Blank
Screen” saver, for the longest phosphor life.
On LCD based monitors, such as the Barco ImageTile displays, it is
not necessary to invoke a screen saver as there is no CRT phosphor
to preserve. However, one can extend the life of the backlight in the
LCD monitor, in addition to realizing great power savings, during
period of user inactivity by quickly entering the Off state. We
recommend setting the work day to be as short as possible to get the
maximum power savings on ImageTile displays.
Available Savers
Lists the available screen savers.
Settings
Changes settings for the selected screen saver.
DPMS Settings After Work Day
If you have an imaging board that supports DPMS calls, then you will
be able to set the DPMS Settings for after the work day. Otherwise, a
text box will be displayed tell you why DPMS functions are not
available.
Amount of Time in each DPMS State
After the work day, the monitor will be placed into one of the following
DPMS Power States: Stand-By, Suspend, or Off. The default setting is
for the monitor to directly go into the Off State and spend no time in
the Stand-By or Suspend states. If the user wishes to go into the
Stand-By or Suspend states before going into the Off state, select the
required amount of time for each state.
If requested, the monitor will first go into Stand-By state, then into
Suspend state, and then into Off state. The properties of DPMS
states are listed in the following table:
BarcoMed software driver installation