Operating instructions

System manual ImageTile 79
BarcoMed software driver installation
BARCO METHEUS CONFIGURATION
TAB
Introduction
After the BarcoMed 3MP2FH Windows Display Driver is installed, a
new Display Properties tab is available for configuring special features
of the BarcoMed 3MP2FH imaging board. Please note that you must
have logged on to Windows using an account with administrator
privileges in order to use the BARCO Metheus Control Panel to
change any display settings.
1) Open the “Display Properties Control Panel” by right clicking on the
desktop, then select “Properties”..
2) Under Windows NT 4.0, Click on the “BARCO Metheus
Configuration” Tab. (see figure 53, below).
Under Windows 2000, click on “Settings” tab. Double click on the
rectangle that represents the BarcoMed 3MP2FH to bring up its
property page. Click on the “BARCO Metheus Configuration” tab
(see figure 54, on the next page).
Under Windows XP, click on “Settings” tab. Double click on the
rectangle that represents the BarcoMed 3MP2FH to bring up its
property page. Click on the “BARCO Metheus Configuration” tab
(see figure 55, on the next page).
Figure 53: Configuration Tab under Windows NT 4.0