Operating instructions

System manual ImageTile 77
system when asked and set the resolution of the first monitor
controlled by the first BarcoMed 3MP2FH. You can then install the
remaining adapters associated with all of the BarcoMed 3MP2FH
boards installed in your system. Repeat steps 3 – 11 until you
have installed all of the adapters.
Setting the Resolution of Your ImageTile Display Panel
To set the resolution of your ImageTile Display Panel(s), see the
sections: “Setting the Resolution of Your ImageTile Display Panel with
DualView Enabled” or “Setting the Resolution of Your ImageTile
Display Panel with DualView Disabled” earlier in this chapter.
BarcoMed software driver installation