Operating instructions

System manual ImageTile 76
until you have installed the drivers for all of the BarcoMed 3MP2FH
boards in your system. Prior to installing the drivers for any additional
imaging boards, we strongly recommend that you set the resolution
for the monitors connected to the first boards installed. If you don’t,
Windows XP may pick a resolution that is not supported by your
display and you will need to reboot in VGA mode to continue. If you
are installing multiple BarcoMed 3MP2FH boards, Windows XP will
prompt you to restart your system once you have finished installing
the drivers for all of the boards. This may take several minutes.
Please be patient.
Reinstalling or Updating your BarcoMed Drivers
To reinstall your current BarcoMed Display Driver or install a new
version of the BarcoMed Display Driver follow the steps below:
1. Right click on the desktop and select “Properties”. Select the
“Settings” tab. Now select the rectangle that represents the
BarcoMed 3MP2FH Imaging Board whose driver you wish to
reinstall or update.
2. Click on the “Advanced” Button.
3. Select the “Adapter” tab and then click on the “Properties”
button.
4. Select the “Driver” tab and click the “Update Driver...” button.
The “Hardware Update” Wizard will start.
5. Select the “Radio Button” beside “Install from a list or specified
location (Advanced)”. Click “Next”.
6. On the “Please choose your search and installation options.” page
of the Hardware Update Wizard, select the “Radio Button” beside
“Don’t search, I will choose the driver to install”. Click “Next”.
7. In the “Select a Device Driver” page of the Wizard click “Have
Disk.” Insert your ImageTile Driver Media into the CD drive and
select the correct device from the “Copy manufacturer’s files from”
drop down menu or browse to the location of your driver and Click
“OK”.
8. Select “BarcoMed 3MP2FH “ in the “Select a Device Driver”
window. Click “Next”.
9. When Windows XP has begun installing the BarcoMed 3MP2FH
driver it will warn you that the software “has not passed Windows
Logo testing to verify its compatibility with Windows XP.” Click
“Continue Anyway” to install the drivers.
10. When the drivers are installed, click “Finish” on the “Update
Driver Wizard” and close the properties page for the device. If you
are installing multiple BarcoMed boards you must reboot your
BarcoMed software driver installation