Operating instructions

System manual ImageTile 73
Disabling DualView under Windows XP
DualView can be disabled on a BarcoMed Imaging Board through the
Monitor Configuration section of the Barco Metheus Configuration Tab
by following the steps listed below.
1. Open the “Display Properties Control Panel” by right clicking on the
desktop, then select “Properties”.
2. Click on “Settings” tab. Double click on the rectangle that
represents first ImageTile display panel attached to the BarcoMed
Imaging Board you are working with to bring up its property page.
Click on the “BARCO Metheus Configuration” tab.
3. Select “Disable DualView” from the “Monitor Configuration” drop
down menu (see figure 51, below). Click “OK”, twice. Your system
will automatically shutdown and restart.
Figure 51: Barco Metheus Configuration Tab – Disabling DualView
4. When your machine comes back up, you will need to re-set up
your ImageTile displays with the desired display settings.
If you wish to Disable DualView on more than one BarcoMed 3MP2FH
Imaging Board repeat steps 1 – 4 above for each board.
BarcoMed software driver installation