Operating instructions

System manual ImageTile 72
3. Select the “Adapter” tab and then click on the “List All Modes…”
button. Select the resolution and refresh rate that your ImageTile
display supports from the dialog box and click “OK”.
Note: The resolutions shown will be based on the number of
heads the imaging board supports.
For example: The BarcoMed 3MP2FH Imaging Board
supports two ImageTile display panels. If the resolution of
each display is 1536x2048x256, Windows XP will display the
resolution as 3072x2048x256. If necessary you can change
the number of display panels later by using the Barco
Metheus Configuration Tab.
4. Click “OK” on the bottom of the Adapter Control Panel. If the
“OK” button on the bottom of the Adapter Control Panel is not
visible, press the “Tab Key” once and then press “Enter”. Your
ImageTile display(s) should now synchronize and display the
Windows desktop.
5. Click “Yes” if asked, “Your desktop has been reconfigured. Do
you want to keep these settings?”
Repeat steps 1 – 5 to set the resolution of the displays attached to
each BarcoMed 3MP2FH Imaging Board installed in your system.
Figure 50: Windows XP Display Properties Settings Tab for the 3MP2FH with
DualView disabled.
Note: The system shown in figure 50 above is a dual-head, single
BarcoMed 3MP2FH imaging board, no 3
rd
party VGA card
configuration. Your system may look different.
BarcoMed software driver installation