Operating instructions

System manual ImageTile 71
Figure 49: Windows XP Display Properties Settings Tab for the 3MP2FH with
DualView enabled
Note: The system shown in figure 49 above is a dual-head, single
BarcoMed 3MP2FH imaging board, no 3
rd
party VGA card
configuration. Your system may look different.
Setting the Resolution of Your ImageTile Display Panel with
DualView Disabled
If you chose to disable DualView when you installed the BarcoMed
Windows XP driver, Windows XP will display a single virtual desktop
that spans across both displays attached to each 3MP2FH board.
1. To set the resolution for your ImageTile display panel(s), right click
on an empty space of the desktop and select “Properties”. Select
the “Settings” tab (see figure 50 on the next page). Now select
the rectangle that represents the BarcoMed 3MP2FH Imaging
Board you are working with.
SPECIAL NOTE: If you are using the VGA capabilities of your
BarcoMed 3MP2FH Imaging Board, the resolution for that board
may still be set to a VGA resolution of “640 x 480” pixels. If the
BarcoMed 3MP2FH Imaging Board is not running VGA, the device
may not be enabled yet. To enable the device check the “Extend
my Windows desktop into this monitor” checkbox. Do not click
the “Apply” button at this time.
2. Click on the “Advanced” Button.
BarcoMed software driver installation