Operating instructions

System manual ImageTile 60
Figure 33: Windows 2000 Display Properties Control Panel
with DualView enabled.
Note: The system shown in figure 33 above is a dual-head, single
BarcoMed 3MP2FH Imaging Board, no 3
rd
party VGA card, DualView
enabled configuration. Rectangles 1 and 2 represent the two
ImageTile displays of a single board/dual head installation. Your
configuration may look different.
This feature can be installed with ImageTile on a BarcoMed 3MP2FH
by following the steps listed below.
1. Follow the instructions in the section “Initial BarcoMed Display
Driver Installation” to install the BarcoMed 3MP2FH driver for
each 3MP2FH graphics board installed in the system.
2. Double-click the “Add/Remove Hardware” icon in the Microsoft
Control Panel. The Add/Remove Hardware Wizard appears.
3. Click “Next”.
4. In the Choose a Hardware Task page of the wizard select the
radio button beside “Add/Troubleshoot a device”, and click
“Next”. Windows will now search for a new Plug and Play
hardware device to install. When Windows fails to find a new Plug
and Play hardware device, the Choose a Hardware Device page
of the wizard will appear.
5. Select “Add a new device”, and click “Next”.
BarcoMed software driver installation