Operating instructions

System manual ImageTile 57
8. The “Start Device Driver Installation” dialog box will appear. Click
“Next”.
9. Windows will warn you that a digital signature was not found. Click
“Yes” to continue the installation.
10. When the drivers have finished installing, click “Finish” on the
“Completing Found New Hardware Wizard” page.
If you are installing a single BarcoMed 3MP2FH Imaging Board,
Windows 2000 will now prompt you to reboot your system. Click
“Yes”. Boot normally and log in using an account with
administrator privileges. (If you are using a 3rd party VGA card
Windows may not prompt you to reboot the system. However, you
must reboot the system prior to attempting to extend your desktop
to the BarcoMed 3MP2FH and setting its resolution.) To set the
resolution of your display skip to the “Setting the Resolution of
...” section of this chapter.
If you have multiple BarcoMed 3MP2FH Imaging Boards installed,
the “Found New Hardware Wizard” will automatically run again for
each additional BarcoMed 3MP2FH Board installed. Follow the
steps below to install the drivers for each additional board.
11. Windows 2000 Plug and Play will automatically locate the drivers
for the second BarcoMed 3MP2FH board. When Windows warns
you that a digital signature was not found, click “Yes” to continue
the installation.
12. When the drivers have finished installing, click “Finish” on the
“Completing Found New Hardware Wizard” page.
13. Windows will now prompt you to reboot your system. Click “Yes”.
Boot normally and log in using an account with administrator
privileges.
Reinstalling or Updating your BarcoMed Drivers
To reinstall your current BarcoMed Display Driver or install a new
version of the BarcoMed Display Driver follow the steps below:
1. Right click on the desktop and select “Properties”. Select the
“Settings” tab. Now select the rectangle that represents the
BarcoMed 3MP2FH Imaging Board whose driver you wish to
reinstall or update.
2. Click on the “Advanced” Button.
3. Select the “Adapter” tab and then click on the “Properties”
button.
4. Select the “Driver” tab and then click on the “Update Device
Driver” button. The “Upgrade Device Driver” Wizard will start.
Click “Next” to continue.
BarcoMed software driver installation