Operating instructions

System manual ImageTile 56
Installing the Driver Using the Windows 2000 Found New
Hardware Wizard
SPECIAL NOTE: Prior to installing the BarcoMed drivers you MUST
install the BarcoMed Imaging Board(s), connect the ImageTile display
panel(s) to the card(s), and turn the ImageTile display on. Refer to
the Hardware Installation section of this manual for instructions on
installing the BarcoMed Imaging Board(s) and connecting them to the
ImageTile display panel(s).
The following driver installation instructions presume that Windows
2000 is already installed on your system. If you need to install or
reinstall Windows 2000 on your system you must first remove the
BarcoMed Imaging Boards and use a 3
rd
party VGA card and VGA
monitor during the Windows 2000 installation process.
Initial BarcoMed Display Driver Installation
To install the BarcoMed 3MP2FH Windows Display Driver for the first
time follow the steps below, if you are reinstalling the drivers or
installing a new driver release skip to the next section:
1. Install the BarcoMed 3MP2FH Imaging Board(s) into your machine.
Please refer to the hardware installation section of this manual for
more information.
2. Boot the machine, and log in using an account with administrator
privileges.
3. For each 3MP2FH board you have installed, Windows 2000 will
automatically launch the “Found New Hardware Wizard”.
Click “Next” to continue using the “Found New Hardware Wizard”.
4. The Wizard will now install the BarcoMed device drivers. If you are
using the VGA capabilities of the BarcoMed 3MP2FH the Wizard
will list the BarcoMed 3MP2FH as a “Video Controller (VGA
Compatible)”. Otherwise each BarcoMed 3MP2FH board will be
listed simply as “Video Controller”.
Select the radio button beside “Display a list of the known drivers
for this device so that I can choose a specific driver”. Click
“Next”.
5. In the “Hardware Type” page of the wizard, highlight “Display
Adapters” and then click “Next”.
6. In the “Select a Device Driver” page of the wizard click “Have
Disk”. Insert your ImageTile Software CD into your computer's CD
drive or browse to the location of your driver and Click “OK”.
7. Select “BarcoMed 3MP2FH “ in the “Select a Device Driver”
window. Click “Next”.
BarcoMed software driver installation