Operating instructions

System manual ImageTile 55
Re-enabling DualView under Windows 2000
If you have disabled DualView using the method described on the
previous page (or if you installed the driver with DualView disabled)
and decide you want to re-enable it, follow the steps listed below.
1) Open the “Display Properties Control Panel” by right clicking on the
desktop, then select “Properties”.
2) Click on “Settings” tab. Double click on the rectangle that
represents the displays attached to the BarcoMed Imaging Board
you are working with to bring up its property page. Click on the
“BARCO Metheus Configuration” tab.
3. Select “Enable DualView” from the “Monitor Configuration” drop
down menu (see figure 31 below). Click “OK”, twice.
Note: If you are using a 3
rd
party VGA card you may need to press
the “Tab” key once and then “Enter” to select the 2
nd
“OK”. Your
system will automatically shutdown and restart. Your system will
automatically shutdown and restart.
Figure 31: Barco Metheus Configuration Tab – Enabling DualView
4. When your machine comes back up, you may need to re-set up
your ImageTile displays with the desired display settings.
If you wish to re-enable DualView on more than one BarcoMed
3MP2FH Imaging Board repeat steps 1 – 4 above for each board.
BarcoMed software driver installation