Operating instructions

System manual ImageTile 54
Disabling DualView under Windows 2000
DualView can be disabled on a BarcoMed Imaging Board through the
Monitor Configuration section of the Barco Metheus Configuration Tab
by following the steps listed below.
1) Open the “Display Properties Control Panel” by right clicking on the
desktop, then select “Properties”.
2) Click on “Settings” tab. Double click on the rectangle that
represents the first display attached to the BarcoMed Imaging
Board you are working with to bring up its property page. Click on
the “BARCO Metheus Configuration” tab.
3. Select “Disable DualView” from the “Monitor Configuration” drop
down menu (see figure 30 below). Click “OK”, twice. Note: If you
are using a 3
rd
party VGA card you may need to press the “Tab”
key once and then “Enter” to select the 2
nd
“OK”. Your system
will automatically shutdown and restart.
Figure 30: Barco Metheus Configuration Tab – Disabling DualView
4. When your machine comes back up, you may need to re-set up
your ImageTile displays with the desired display settings.
If you wish to Disable DualView on more than one BarcoMed 3MP2FH
Imaging Board repeat steps 1 – 4 above for each board.
BarcoMed software driver installation