Operating instructions

System manual ImageTile 53

To set the resolution of the second ImageTile display attached to the

BarcoMed 3MP2FH Imaging Board you are working with, go back to

the “Settings” tab of the “Display Properties Control Panel”. Attach

the display you detached in step 2 above, by right clicking on the

rectangle that represents it and selecting “Attached”.

Now repeat steps 3 – 7 above for this display.

If you are using a Quad-Head Configuration repeat all of the above

steps for the two displays on the second imaging board.

Special note: After installing DualView and setting the resolutions in a

Quad-Head Congifuration you may need to drag the heads into the

proper position in the window on the “Settings” tab, so that the

arrangement in the window on the “Settings” tab matches the

physical arrangement of your configuration.

After installing DualView use the Barco Metheus Configuration Control

Panel to verify or change your system settings.

Figure 29: The Windows 2000 Display Properties Control Panel Settings Tab

after the drivers have been installed and the resolution set with DualView

Enabled.

Note: The system shown in figure 29 above is a dual-head, single

BarcoMed 3MP2FH Imaging Board, no 3

party VGA card

configuration, your system may look different.

BarcoMed software driver installation