Operating instructions

System manual ImageTile 51
Click “OK” on the bottom of the Adapter Control Panel. If the
“OK” button on the bottom of the Adapter Control Panel is not
visible, press the “Tab” key once and then “Enter” to select
“OK”.
4. Click “OK” in the “Windows will now apply your new desktop
settings” dialog box. Your high resolution display(s) should now
synchronize and display the Windows desktop.
5. Click “Yes” when asked, “Your desktop has been reconfigured.
Do you want to keep these settings?”
Repeat steps 1 – 5 for each monitor/display panel on all the
BarcoMed Imaging Boards installed in your system.
Figure 28: The Windows 2000 Display Properties Control Panel Settings Tab
after the drivers have been installed and the resolution set.
Note: The system shown in figure 28 above is a single BarcoMed
3MP2FH Imaging Board, no 3
rd
party VGA card configuration, your
system may look different.
BarcoMed software driver installation