Operating instructions

System manual ImageTile 49
restart your computer at a later time. If the installation failed, click
“Finish” to exit the Wizard (see figure 27).
Figure 25
Windows will warn you that you must restart your computer before
the new settings will take effect (see figure 26). Click Yes to restart
your computer. When your computer restarts, log in using an
account with administrator privileges.
Figure 26
If the Wizard failed to successfully install the drivers for all of the
displays supported by your BarcoMed 3MP2FH imaging board(s),
the Wizard will advise you that the installation failed (see figure 27
on the next page ). Click “Finish” to exit the Wizard and try
reinstalling the drivers following the steps above or using the steps
outlined in “Reinstalling or Updating your BarcoMed Drivers”
section found later in this chapter.
Special Note: If you installed the drivers with DualView disabled,
Windows 2000 will still show two devices installed for each BarcoMed
3MP2FH Imaging Boards installed under “Display Adapters” in the
“Device Manager Control Panel”. The second device will be disabled.
This is normal. Do NOT try to enable any of the disabled display
adapters. If you wish to enable DualView, you will need to reinstall the
drivers with DualView enabled.
BarcoMed software driver installation