Operating instructions

System manual ImageTile 48
Figure 22
11. While the driver is being installed, the screen shown in figure 23
will be visible.
Figure 23
12. For each display supported by your ImageTile imaging board(s)
the Wizard will display the screen shown in figure 24. Click “Yes”
to continue.
Figure 24
13. If the Wizard has successfully installed the drivers for all of the
displays supported by your BarcoMed 3MP2FH imaging board(s),
the Wizard will prompt you to reboot your system (see figure 25).
Click “REBOOT” to restart your computer now. Click “Cancel” to
BarcoMed software driver installation